Performance evaluation of the two-input buck converter as a visible light communication high-brightness led driver based on split power

This work proposes a high-efficiency High-Brightness LED (HB-LED) driver for Visible Light Communication (VLC) based on a Two-Input Buck (TIBuck) DC/DC converter. This solution not only outperforms previous approaches based on Buck DC/DC converters, but also simplifies previous proposals for VLC drivers that use the split power technique with two DC/DC converters: one is in charge of the communication tasks and the other controls the biasing of the HB-LED (i.e., lighting tasks). The real implementation of this scheme requires either two input voltage sources, one of which is isolated, or one DC/DC converter with galvanic isolation. The proposed implementation of splitting the power is based on a TIBuck DC/DC converter that avoids the isolation requirement, overcoming the major drawback of this technique, keeping high-efficiency and high communication capability thanks to the lower voltage stress both across the switches and at the switching node. This fact allows for the operation at very high frequency for communication purposes, minimizing Citation: Aller, D.G.; Lamar, D.G.; García-Mere, J.R.; Arias, M.; Rodriguez, J.; Sebastian, J. Performance Evaluation of the Two-Input Buck Converter as a Visible Light Communication HighBrightness LED Driver Based on Split Power. Sensors 2024, 24, 6392. https://doi.org/10.3390/s24196392 Academic Editor: Chen Chen Received: 14 September 2024 Revised: 26 September 2024 Accepted: 29 September 2024 Published: 2 October 2024 Copyright: © 2024 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https:// creativecommons.org/licenses/by/ 4.0/). switching power losses, achieving high efficiency and providing lower filtering effort. Moreover, the duty ratio range can also be adapted to the useful voltage range of the HB-LED load to maximize the resolution on the tracking of the output volage. The power is split by means of an auxiliary Buck DC/DC converter operating at low switching frequency, which generates the secondary voltage source needed by the TIBuck DC/DC converter. This defines a natural split of power by only processing the power delivered for communications purposes at high frequency. A 7 W output-power experimental prototype of the proposed VLC driver was built and tested. Based on the experimental results, the prototype achieved 94% efficiency, reproducing a 64-QAM digital modulation scheme and achieving a bit rate of 1.5 Mbps with error in communication of 12%.