RUO Principal

Repositorio Institucional de la Universidad de Oviedo

Ver ítem 
  •   RUO Principal
  • Producción Bibliográfica de UniOvi: RECOPILA
  • Artículos
  • Ver ítem
  •   RUO Principal
  • Producción Bibliográfica de UniOvi: RECOPILA
  • Artículos
  • Ver ítem
    • español
    • English
JavaScript is disabled for your browser. Some features of this site may not work without it.

Listar

Todo RUOComunidades y ColeccionesPor fecha de publicaciónAutoresTítulosMateriasxmlui.ArtifactBrowser.Navigation.browse_issnPerfil de autorEsta colecciónPor fecha de publicaciónAutoresTítulosMateriasxmlui.ArtifactBrowser.Navigation.browse_issn

Mi cuenta

AccederRegistro

Estadísticas

Ver Estadísticas de uso

AÑADIDO RECIENTEMENTE

Novedades
Repositorio
Cómo publicar
Recursos
FAQs

Hot strip flatness optimization by means of edge masking in the ROT

Autor(es) y otros:
Peregrina, S.; García Redondo, J. M.; Fernández Quiroga, P.; González García, Diego; García Martínez, Daniel FernandoAutoridad Uniovi
Fecha de publicación:
2006
Editorial:

EDP Sciences

Versión del editor:
http://dx.doi.org/10.1051/metal:2006147
Citación:
Revue de Métallurgie, 103(9), p. 381-387 (2006); doi:10.1051/metal:2006147
Descripción física:
p. 381-387
Resumen:

The control of temperature distribution across the strip is essential for the hot strip flatness improvement. Hot strips of Arcelor in Avilès may display wavy edge defects that are generated after the finisher and are attributed to residual stresses introduced by the accelerated cooling on the runout-table. A first approach has established that the thermal drop on the run-out-table has a significant effect on flatness, at the edges in particular. Among several systems that may control temperature at the edges, the edge masking technology has been selected, considering the previous implementation on CSP mills. Wavy edges are considerably removed or even suppressed on the operator side, while they are reduced but not eliminated on the drive side

The control of temperature distribution across the strip is essential for the hot strip flatness improvement. Hot strips of Arcelor in Avilès may display wavy edge defects that are generated after the finisher and are attributed to residual stresses introduced by the accelerated cooling on the runout-table. A first approach has established that the thermal drop on the run-out-table has a significant effect on flatness, at the edges in particular. Among several systems that may control temperature at the edges, the edge masking technology has been selected, considering the previous implementation on CSP mills. Wavy edges are considerably removed or even suppressed on the operator side, while they are reduced but not eliminated on the drive side

URI:
http://hdl.handle.net/10651/30740
ISSN:
2271-3646
DOI:
10.1051/metal:2006147
Colecciones
  • Artículos [37532]
  • Informática [872]
Ficheros en el ítem
Thumbnail
untranslated
P381.pdf (1.930Mb)
Métricas
Compartir
Exportar a Mendeley
Estadísticas de uso
Estadísticas de uso
Metadatos
Mostrar el registro completo del ítem
Página principal Uniovi

Biblioteca

Contacto

Facebook Universidad de OviedoTwitter Universidad de Oviedo
El contenido del Repositorio, a menos que se indique lo contrario, está protegido con una licencia Creative Commons: Attribution-NonCommercial-NoDerivatives 4.0 Internacional
Creative Commons Image