Experimental and Numerical Study of the Thermal Properties of Dry Green Swales to Be Used as Part of Geothermal Energy Systems
Autor(es) y otros:
Palabra(s) clave:
construction and demolition waste (CDW)
green infrastructure (GI)
ground-source heat pumps (GSHP)
hot-box test
low impact development (LID)
modified transient plane source (MTPS)
nature-based solutions (NBS)
Sustainable Drainage System (SuDS)
Fecha de publicación:
Editorial:
MDPI
Versión del editor:
Citación:
Resumen:
Low-enthalpy geothermal systems are a promising source for renewable and clean energy for heating, cooling, and air conditioning residential buildings, contributing to the reduction in greenhouse gas emissions in line with the United Nations’ Sustainable Development Goals. Previous research emerged around the geothermal utilization of Sustainable Drainage Systems (SuDS) as multifunctional surfaces for stormwater control and energy saving, developing the water–energy nexus. However, these studies did not comprehensively considered the energy aspects for SuDS design, using non-standardized tests to measure the main thermal parameters. This research aims to address this gap by proposing a novel hybrid engineering procedure to study the thermal properties of SuDS layers and materials through experimental tests combined with steady-state and transient numerical simulations, using green swales operating under dry and wet conditions as a first case study for SuDS techniques. Novel materials incorporated into dry swales (expanded clay and construction and demolition waste) were tested. The results validated this new methodology, reporting an increase of 87% under dry conditions, and 51% under wet scenarios in the thermal insulation performance in comparison to standard materials. A better thermal performance of the systems can be achieved by approaching SuDS design from a holistic viewpoint that integrates energy aspects.
Low-enthalpy geothermal systems are a promising source for renewable and clean energy for heating, cooling, and air conditioning residential buildings, contributing to the reduction in greenhouse gas emissions in line with the United Nations’ Sustainable Development Goals. Previous research emerged around the geothermal utilization of Sustainable Drainage Systems (SuDS) as multifunctional surfaces for stormwater control and energy saving, developing the water–energy nexus. However, these studies did not comprehensively considered the energy aspects for SuDS design, using non-standardized tests to measure the main thermal parameters. This research aims to address this gap by proposing a novel hybrid engineering procedure to study the thermal properties of SuDS layers and materials through experimental tests combined with steady-state and transient numerical simulations, using green swales operating under dry and wet conditions as a first case study for SuDS techniques. Novel materials incorporated into dry swales (expanded clay and construction and demolition waste) were tested. The results validated this new methodology, reporting an increase of 87% under dry conditions, and 51% under wet scenarios in the thermal insulation performance in comparison to standard materials. A better thermal performance of the systems can be achieved by approaching SuDS design from a holistic viewpoint that integrates energy aspects.
DOI:
Patrocinado por:
This investigation was supported by the FICYT under the GRUPIN project, with the grant number SV-PA-21-AYUD/2021/51328, which was co-financed with EU FEDER funds. Carlos Rey-Mahía acknowledges the University of Oviedo for a Predoctoral Grant, reference PAPI-22-PF-8.
Colecciones
- Artículos [35482]
- Construcción e Ingeniería de Fabricación [429]
- Investigaciones y Documentos OpenAIRE [7762]